theflooringblog

Welcome


Welcome
Method Or Recoating Hardwood Floors

Over time, it is obvious that your hardwood floor will become scratched and dull from general wear and tear.   In case your hardwood floor is fitted with polyurethane, it can normally be recoated without the requirement of sanding the whole floor at first.   Recoating is fundamental if the floor is gently scratched and worn, the finish has not worn, and it doesn't have a gathering of wax or different chemicals.   These will bring about adhesion issues and make the floor reject the new finish which can lead to detaching and shedding.   These will cause adhesion problems and cause the floor to reject the new finish which can cause peeling and flaking.   Recoating is an easy process, like Floor Varnishing Annapolis, that entails deep cleaning and scuffing the timber surfaces uppermost layer of the finish.   At that point, another new layer of finish is added.   Recoating will invigorate the polish and remove any slight staining that has yet to infiltrate the timber.   It invigorates your wood floor and prolongs the life of its protective finish layers.   It is advisable that you recoat your floor while it still looks good.   This will prolong its life and reduce the frequency of refinishing.

Recoating a hardwood floor should not be mistaken for revamping a hardwood floor.   The last entails deep sanding of the floor to open up the wood, and is necessary for situations where there are big scratches, damage or if waxing has been done on the floor.   To check whether your floor can be recoated, you ought to do a little patch test in a subtle zone.   It is ideal to do the testing along a wall where cleaners might have accumulated.   Thoroughly clean the area with the use of wood floor cleaner and then lightly sand with fine sandpaper.   You ought to then wipe away all bits of dirt.   You should then use polyurethane floor finish in the region and wait for one day.   The layer should be fine, not undulated or an orange shell feel.   Scratch the layer with moderate force using a coin and it ought not to flake or peel.   In the likelihood that the surface fails these tests, the floor will require being broadly sanded and revamped.

For recoating http://twodudescleaningservice.com/about-us/ to happen on your hardwood floor, it needs to initially be moderately sanded with a screen disk.   Then, the floor ought to be cleared and vacuumed to remove the wood dirt.   You then should dampen a tack rag with pure mineral spirits and run the rag over the floor to pick up any fine dust and oily residue.   At the time of fitting the finish, it is recommended you make use of a similar finish as was used to guarantee compatibility.   If an existing coating is not compatible with the new coating, there are complications such as peeling that can occur.
This site was built using